The HDMI over IP H.264/H.265 PoE Extender Transmitter and Receiver combination allows HDMI source and display equipment to be extended locally up to 330ft (100m) at up to 4K @ 60Hz resolution via Cat5e/6 cable in point-to-point, point-to-multipoint and multipoint-to-multipoint configurations via a local Ethernet network, in a low bandwidth, flexible, expandable and cost effective manner, without the need to install dedicated cabling systems. The exceptionally low bandwidth requirements of this device combination allows for streaming audio/video content over a local network, over WiFi, and over the Internet for distributed installations spread-out throughout the globe. The transmitter accepts a 1080p @ 60Hz video and streams the content to the Receiver, where the signal is up-scaled up to 4K @ 60Hz to be displayed on a 4K monitor. The Receiver also accepts H.264/H.265 video streams from other transmitting devices of up to 4K @ 60Hz, and supports a USB 3.0 Type A connector for storing and playback of local content from an external USB drive.
 
Typical Applications:
Commercial and residential AV systems
Classroom projector systems
Digital signage
Boardroom systems
Collaborative PC systems
Medical information systems
 
Note: These devices support PoE (PD) and may be powered by a PoE (PSE) Ethernet Switch.
 
HDMI 1.3
Supports up to 1080p resolutions
Motion JPEG compression with Very low latency
Supports 100’s of Transmitters and Receivers, depending on network bandwidth
Supports point-to-point, point-to-multipoint and multipoint-to-multipoint applications
Transmission up to 330ft (100m) over Cat5e/6
Up to 390ft (120m) between the TX and RX when no LAN switch is used
Supports IR transmission for remote control
PoE powered
Control via any web device (mobile, tablet) with use of model 500811 (Pro Digital Network Controller)